If you are unsure, contact your instructor.Īnswers Note: Refer to the Answers Lab Manual for the procedures to initialize and reload devices.Īnswers Note: The default bias template used by the Switch Database Manager (SDM) does not provide IPv6 address capabilities. Note: Make sure that the routers and switches have been erased and have no startup configurations. Refer to the Router Interface Summary table at the end of the lab for the correct interface identifiers. Depending on the model and Cisco IOS version, the commands available and output produced might vary from what is shown in the labs. Other routers, switches and Cisco IOS versions can be used. The switches used are Cisco Catalyst 2960s with Cisco IOS Release 15.0(2) (lanbasek9 image). Note: The routers used with CCNA hands-on labs are Cisco 1941 ISRs with Cisco IOS Release 15.2(4)M3 (universalk9 image). You will also verify end-to-end connectivity using the ping and traceroute commands. You will use show commands to view IPv6 unicast and multicast addresses. In this lab, you will configure hosts and device interfaces with IPv6 addresses and explore how the all-router multicast group is assigned to a router.
#Cisco 1941 router configuration step by step how to
Understanding how the all-router multicast group is assigned and how to control address assignments for the Solicited Nodes multicast group can prevent IPv6 routing issues and help ensure best practices are implemented. Knowledge of the Internet Protocol version 6 (IPv6) multicast groups can be helpful when assigning IPv6 addresses manually. Part 3: Verify End-to-End Connectivity Background / Scenario Part 2: Configure IPv6 Addresses Manually
![cisco 1941 router configuration step by step cisco 1941 router configuration step by step](https://i.ytimg.com/vi/XVEZF6-bC78/hqdefault.jpg)
Part 1: Set Up Topology and Configure Basic Router and Switch Settings 7.2.5.4 Lab – Configuring IPv6 Addresses on Network Devices Answers Lab – Configuring IPv6 Addresses on Network Devices ( Answers Version)Īnswers Note: Red font color or gray highlights indicate text that appears in the instructor copy only.